DESCRIPTION

SelectGuard Clear 30% Acrylic Solvent Based Sealer is a specially formulated 30% solids solvent based acrylic specifically designed for sealing and protecting all types of plain, colored and decorative concrete surfaces. SelectGuard Clear 30% Acrylic Solvent Based Sealer is a non-yellowing, non-styrenated sealer that is resistant to oil, greases, gasoline, deicing salts, ultra violet rays, wet and dry abrasion and many household chemicals. This sealer contains specially formulated resins and solvents that are designed for maximum penetration into the concrete surface for extended durability and wear resistance.

BENEFITS

· Seals all concrete surfaces, providing glossy appearance, easy maintenance.

· Non-yellowing under ultra violet exposure.

· Resistant to mold, mildew and many other organic stain products.

· Helps minimize spalling of exterior concrete.

· Can be coated with high grade commercial wax.

· Can be applied to concrete as soon as it sets.

· Properly cures and hardens new concrete for improved abrasion resistance.

· Deep penetration increases abrasion and wear resistance.

USES

· Spray Deck Knock Down

· Swimming Pools

· Integral Colored Concrete Overlays

· Exterior and Interior Surfaces

· Ornamental Pre-cast Concrete

· Concrete Masonry Units

APPLICATION

Surface Preparation: New concrete surfaces must be completely dry, clean and free from curing agents, paint or any other compounds which would prevent penetration of the sealer into the concrete surface. Pressure washing and acid etching is recommended prior to sealing plain concrete surfaces. For sealing stamped concrete, refer to the stamped overlayment application instructions.

Application: Sealer should be applied by ¼ inch nap solvent resistant roller, hand held sprayer, or by an airless industrial sprayer. Apply first coat and allow to dry thoroughly before applying the second coat. For maximum performance, twelve (12) hours between coats is recommended. When sealing hard troweled, dense concrete surfaces, SelectGuard Clear 30% Acrylic Solvent Based Sealer may be thinned for the first coat to increase penetration. Dilute 1:1 with DCF Solvent on the first coat only.

Clean Up: Tools and equipment should be cleaned with DCF Solvent.

CHEMICAL RESISTANCE

Chemical resistance to strong reagents after twenty-four (24) hours of exposure was determined on 1 mil dry films that had been cast on glass plates.

page 2